I want to make a table lamp with a laser cutting.

 

 

This is the source of my original design inspiration.

 

At first, I wanted to make a house that would shine, but later I thought it was a little too ordinary. I suddenly saw some posts about the Christmas elements of the snowy mountains and the deer. On second thought, or I'll design a snow mountain deer table lamp, and Christmas is coming, and there is still half a year left, and then some Christmas elements are added in it.

This is my original design, with snow, deer and Christmas trees. But later I found that the snow I designed was a little too messy, and there were too few small designs inside, which would lead to too few light sources after installing the lights later, which was not bright enough.

This is my final design. I replaced the snowflakes with a circle, which is a little simpler, adding a lot of trees, houses and Christmas elements as light sources.

I will start printing my first finished product.

But in fact, I think my most difficult thing is not the design drawing, but the problem that the finished product cannot be assembled.

My buckle design is so small that it can't be assembled with it and can't get stuck.

I remade my buckle position again.

I have narrowed the position of these buckles.

 

The buckles in these positions have been widened.

The next day, I reprinted it and finally got the finished product.

Later, I installed a led light in this position, which showed a very good effect at night.

This is the effect of the dark environment.

This is the effect of turning on the lights during the day.

The laser cutting ratio is very important. Because the proportion is not suitable, I reworked it, which is not only a waste of energy, but also a waste of materials and resources. Therefore, before making the model, you must ask the teacher more, control the overall size and proportion, and then start drawing the AI cutting map.

 

If it is the first time to do it, practice is also very important, because only when you have tried it will you know that it is like this.

 

If I continue to make similar projects next time, I must make it clear on the size on the buckle, and then make the graphics, because if you can't get stuck, your whole model will be done in vain.